[f] AMB on Facebook

Initial set up issue β24 board

beta24

Re: Initial set up issue β24 board

Postby amb » December 10th, 2017, 10:32 pm

Yes, good advice from @mpa2. Since swapping transistors from side to side had no effect, then the imbalance must be coming from elsewhere.
User avatar
amb
Site Admin
 
Posts: 10381
Likes: 175 posts
Liked in: 482 posts
Joined: March 29th, 2010, 9:49 pm
Location: Sunnyvale, CA
Country: United States (us)

Re: Initial set up issue β24 board

Postby Pieterh » December 11th, 2017, 12:40 am

Ok. I 'll do some additional checking on cold joints /measuring / wrong parts .... I'll keep you updated, but this will take some time.

Ti and Micheal, thanks for helping!
Pieterh
 
Posts: 132
Likes: 93 posts
Liked in: 54 posts
Joined: December 29th, 2015, 12:50 am
Location: Netherlands
Country: Netherlands (nl)

Re: Initial set up issue β24 board

Postby daniele86 » April 26th, 2018, 9:06 am

Hi Pieterh,
I've seen your awesome build! Well done. You give me some extra ideas to complete mine, specially in cable routing. Great. =)

But how did you finished the board after this problem?
I think I'm in front off the same: I turn VR2 till the end and can't reach 40mV across R45 (R46), it stops to 29mV. Then when turning VR3 all go down.

Thanks
d
daniele86
 
Posts: 164
Likes: 13 posts
Liked in: 11 posts
Joined: June 28th, 2012, 11:53 pm
Country: Italy (it)

Re: Initial set up issue β24 board

Postby Pieterh » April 27th, 2018, 1:07 am

Dear Daniela, ty for your kind words.

About ' my ' issue. It may be different from yours. I could get biases at normal vales (40mV) but I couldn't get the offset in the necessary range. My one board with an issue died during testing by a short. So I had to start all over with one board. The new board worked well from the start.

daniele86 likes this post.
Pieterh
 
Posts: 132
Likes: 93 posts
Liked in: 54 posts
Joined: December 29th, 2015, 12:50 am
Location: Netherlands
Country: Netherlands (nl)

Previous

Return to β24 fully-differential power amplifier

Who is online

Users browsing this forum: No registered users and 0 guests

Quick Links

AMB audio DIY resources
AMB audio shop

cron