952-1504-ND STANDOFF M/F HEX M3 BRASS 13MM
2036K-ND SPACER RND #4 SCREW .125"L ALUM
I just wanted others to know that this combination will not work 100% to mount the display and lcduino board together onto the FPE front panel. the male end protrudes too much and because the default hole is tapped at 4-40 and the M3 male end does not fit inside this hole, it will prevent the display from seating properly.
A slightly thicker spacer is needed to make it align properly. I ended up not using the spacer i bought and used some RC car aluminum spacers instead, something like:
Tamiya Aluminum Spacer Set 5.5mm
it has a combination of 0.5mm to 3.0mm spacers. I used 0.5mm + 3.0mm and the fit is perfect now.
just in case somebody is running into the same issue as me.
-joe
